If you are experiencing issues with no/low spray, follow these steps to resolve
Check tank for water flow
- Unplug machine
- Remove solution tank & fill with water
- Hold tank over sink & push up on x-valve on end of cap
- Water should flow out
- Remove cap & soak in warm water for 30 minutes if no water flow
- Check trigger for tension if water flows out of cap
Check trigger for tension
- Remove handle & re-install if no tension
- Check 3 handle screws
- Top screw should be recessed 1/2 inch from outside of raised screw hole
- Check 3 handle screws
- Re-install tank
- Squeeze trigger
- Spray is gravity fed > It may take 15-30 seconds to reach spray tips
- Clean spray bar by inserting a paper clip into spray hole
Did this resolve your issue?
- We can likely repair this issue > Find your nearest BISSELL Service Center here
- If you still need assistance > Contact Us
Great!
We're glad you can get back to cleaning! Should you need any additional support, please review one of the related articles below or head back to support.bissell.com.
